CODICO - YOUR COMPONENT DESIGN-IN COMPANY

SERIES 100 FILTERED CONNECTORS: TOP QUALITY @ LOW COST

2008-03-01

SPECTRUM CONTROL has added the new, inexpensive Series 100 chip-on-board connectors to its range of filtered D-Sub connectors.

Series 100 connectors feature a significantly lower-cost design compared to bushing filters, and they come fully integrated within a metal housing. As a result, they offer exceptional value for use in applications where protection against electromagnetic interference is vital. SPECTRUM CONTROL offers 10 different filter curves – with incremental capacitances from 50pF to 47000pF – to accommodate a wide range of signal rates. The connectors are available with 9, 15, 25 or 37 contact positions in a variety of mechanical configurations, and the corresponding test adapters are also offered. To make the Series 100 fully compatible as a “drop in” replacement for unfiltered connectors, all three versions are available with an 8.08mm, 10.4mm or 14.99mm PCB footprint for 90° PCB mounting.

In addition to the new chip-on-board filtered connectors, SPECTRUM CONTROL continues to develop and manufacture a broad range of filtered D-Sub connectors for various communications applications, such as:

  • Filtered high-density adapters for VGA interfaces
  • Filtered adapters for 2,048 M-bit interfaces
  • Filtered connectors for test voltages of up to 1,400VDC
  • Combo D-Sub filter connectors for up to 40A.



A number of custom solutions are offered to augment the standard range.



S10

Imp_1_2008_S10_SPECTRUM_Bild_kl.jpg

This website uses cookies in order to give you the best possible service. By using this website you comply with the use of cookies.
Further information can be found here

Nicht mehr anzeigen