CODICO - YOUR COMPONENT DESIGN-IN COMPANY
Products | 

Narrow Band PLC

93_NarrowBandPLC_Agjp311_AWoGi-Fotoliacom_755.jpg

Narrow Band PLC - PLC with greater range but lower data rate

 

The term Narrow Band Power Line Communication (NB PLC) designate a form of communication where multiple carrier frequencies are being used to transmit data. NB PLC operates in the range of 5 kHz to 500 kHz.

 

Subcategories of Narrow Band PLC:

Produktkategorie CENELEC A-Band

CENELEC A-Band

Reserved for utilities

 
Produktkategorie CENELEC B-D-Band

CENELEC B-D-Band

CENELEC B- to D-Band Communication services

 
Produktkategorie FCC-Band

FCC-Band

Frequency Bands

 
Produktkategorie RS485 Replacement

RS485 Replacement

Serial data transmitted over power line

 

Our suppliers in this category Narrow Band PLC:

GRIDCOMM

GRIDCOMM provides power line communications semiconductors, devices and systems that enable the transformation of the electricity grid into a smart grid.

INFOContact

Your contact :

Your contact for GRIDCOMM:  Werner Reis
Werner Reis
Product Line Manager
+49 8141 357264

Order now: Samples Narrow Band PLC

TIME-TO-MARKET: You can find the latest evaluation boards and samples in our shop. So that you do not lose any valuable time.

Modulation schemes are Frequency Shift Keying (FSK) or Quadrature Phase Shift Keying (QPSK). Beside them modern solutions also use the Orthogonal Frequency Division Multiplexing (OFDM) method. With OFDM the user data is split into several data streams with lower data rate. Each of these lower rate data streams are then modulated by a conventional modulation scheme such as Quadrature Amplitude Modulation (QAM) with small bandwidth and after the modulation the RF signals are combined. At the end, this method results in a robust transmission system with reasonable data rates.

 

BB PLC can be applied and used on any kind of wires, independently if there is an AC voltage on the line or DC voltage present in order to supply other components connected to these wires or if these are dead wires.

 

The attenuation of the signal on the wires is relatively low because of the low frequencies, which extends the reach. Reach and achievable user data rate are much dependent on the capacity of the wires and the distortion.

 

In the area of NB PLC CODICO offers integrated circuits, modules and evaluation systems according to the IEEE 1901.2 Standard. Beside that several other operation modes can be selected like G3-PLC, PRIME, G.hnem etc.

This website uses cookies in order to give you the best possible service. By using this website you comply with the use of cookies.
Further information can be found here

Nicht mehr anzeigen